PRASTEL GT+, Manual

Page: 4 / 18

GT+ ENGLISH
ISGTPLUSEN_11_14.doc
4
Init. counter
Resets the operation counter
Delete Total
Erases the entire UNIK card memory
Single code
Erases single transmitters stored in
the UNIK card memory, one at at time
Files UNIK->File Backs up a UNIK card memory in the
GT+ memory
File->UNIK Copies a backup stored in the GT+ to
UNIK card memory
FILES Read Reads backups stored in the GT+
memory
Delete Erases a backup file in the GT+
memory
Format GT+ Formats the entire GT+ memory
OPTIONS Language Configures the language for the GT+
menus
LCD contrast Adjusts the contrast of the display
Buzzer Activates the buzzer
Info Reads the GT+ release and serial
number
5. OPERATING INSTRUCTIONS
Warning:
The first time the terminal is turned on, the GT+ asks for an installer code which will be locked into its memory.
Enter the desired code, which may be between 1 and 63. This code must be the same for all your installations.
Confirm by pressing OK.
WARNING: once you have confirmed the installer code you can no longer change it.
“RECEIVERS” Menu:
This menu allows a receiver memory, whether external (removable) or
internal, to be read, programmed or deleted.
When using an external memory, power the GT+ with an external power
supply via its micro-USB port.
Connect the supplied memory-receiver connecting cable to the GT+
“Memory” port.
Connect the memory module to the red 12-pin connector at the end of the
connecting cable. Check that the polarity is correct when you connect the
memory using the locating pin integrated into the red connector.
Use the red 8-pin connector for MRxE or MRxS receivers. If the receiver is
already powered, the GT+ shall automatically be powered by the receiver.
Otherwise the GT+ must be powered by an external power supply via its
micro-USB port.
“Read” Menu
This menu displays all the receiver information, i.e. the list of transmitter
codes in the memory, the relay command configuration, the site and extra
site codes, the memory used and the type of receiver.
An error in communicating with the memory or the receiver is indicated by
the "No memory!" message.
If the installer code in the memory or the receiver is incorrect, the "Inst code
ERR!" message will appear.
If the memory type or the receiver does not support a requested piece of
information, the "Not available !" message will be displayed.
Not available!
Inst code ERR!
No memory!
> Read
Program
>RECEIVERS
TRANSMITTERS