Praher Plastics Aquastar Comfort 1001, Manual

Page: 40 / 60

www.praherplastics.com 12
12.2 Winter Position
Winter Position as release for the sealing system during winter time

Press key „On“ for basic position

Press keys „Test“ and „On“ at the same time (min. 4 sec) until the Aquastar start to run

When the winter position has been reached the Aquastar will automatically turn itself off

Pr
ess key „On“ for basic position
The valve does not seal anymore!
13 Setting of the times
13.1 Setting the time delay (20sec
– 23min)
Set the time with the potentiometer (knob P3)

Turn the potentiometer
clockwise
→ longer time
counter clockwise
→ shorter time

Trigger
backwash procedure with key “Test”
13.2 Setting the backwash time (50sec
– 9min)
Set the time with the potentiometer (knob P1)

Turn the potentiometer
Clockwise
→ longer time
counter clockwise
→ shorter time

Trigger backwash procedure with key
“Test“
13.3 Setting the rinsing time (25sec
– 200sec)
Set the time with the potentiometer. (knob P2)

Turn the potentiometer
clockwise
→ longer time
counter clockwise
→ shorter time

Trigger backwash procedure with key
“Test”
14 Setting switch points backwash time
The switch points for backwash time are set with switch S2 on the circuit board.
4 switch points for backwashing are available
OFF 3 days 7 days 14 days
ATTENTION! Prior to setting/adjusting the switch points backwashing the valve needs
to be on position “FILTER” and the Aquastar has to be turned off. (see page 11)
S2