7/20
STAND-ALONE MODE
Operate the projector without connecting a controller, enable the master mode in the operation panel, the projector
will run in Stand-Alone mode automatically.
DMX address can be set without limitations.
MASTER/SLAVE MODE
Many projectors can run synchronously in the Master/Slave mode by linking them with each other. Select one
projector as the master with setting options at any mode of master’s modes enabled and make the other projectors as
the slaves with setting options slave mode enabled and their DMX start address “001”.
Using XLR-XLR cables, Connect the first fixture’s output to the second fixture’s input, and connect the second fixture’s output to the
third fixture’s input and connect the rest fixtures in the same way. Eventually connect the last fixture’s output to a DMX terminator as
shown in the figure below.
After powered, the groupwill run in synchronous Master/Slave Mode.
XLR
Terminator
Input
Output
Input
Output
Input
Output
Master
Slave
Slave
