4/20
INSTALL THE PROJECTOR
Safety cord
Clamp
Handle
Operation menu
Safety cord hold
Please run the safety
cord thyough a safety
cord hole for safety
Warning
Take 2 clamps and the safety cord out from the package and mount 2 clamps on the underside of fixture with 2 retainers attached to
each clamp. Hang the fixture on the structure and fasten the screws attached to each clamp. (See the
WARNING
on the underside of
the base as shown above)
To pass SAFETY CORD through 1 HOLE for safety!
Always ensure that the projector is firmly
anchored to avoid vibration and slipping whilst functioning. Always ensure that the structure that you are going to mount the projector
is secure and is strong enough to support a weight of each projector.
WARNING:
1. A device MUST be lifted or carried by its HANDLES instead of clamps.
2. For safety the safety cord should afford 10 times the unit’s weight.
POWER SUPPLY-MAINS
Connect the power cord as follows:
L (live) =brown
E (earth) =yellow/green
N (neutral) =blue
Use the plug provided to connect the mains power to the projector paying attention to the voltage and frequency marked on the panel
of the projector. It is recommended that each projector be supplied separately so that they may be individually switched on and off.
IMPORTANT
It is essential that each projector is correctly earthed and the electrical installation conforms to all relevant standards.
