6/20
SETUP OPTIONS-PROJECTOR CONFIGURATION
A device configuration can be set conveniently via pressbutton switch and LCD display.
Launch the projector. Press button ENTER more than 5 seconds to unlock panel, LED display shows functional menus which have
their own sub-menus for designated functions, the below is the details
Press button UP or DOWN if you want to browse through the various Setup Options.
Press button ENTER to save your settings or enter the next menu.
Press button UP or DOWN to shift.
Press button FUNC, it will return to the upper menu one by one. If you stay for minutes defaulted will show display status
automatically.
TO SET THE DMX START ADDRESS
Each projector must be given a DMX start address so that the correct projector responds to the correct control signals. This DMX start
address is the channel number from which the projector starts to “listen” to the digital control information being sent out from the
controller. The fixture have 3 DMX modes. There are standard mode, extended mode and short mode. For example standard mode
has 20 channels, so set the No. 1 projector’s address 001, No. 2 projector’s address 021, No. 3 projector’s address 041, No. 4
projector’s address 061, and so on.
Launch the projector. Press button ENTER more than 5 seconds to unlock panel.
Press button FUNC to display
DMX address
;
Press button UP and DOWN, you can set the address;
Press button ENTER to confirm, after powered next time, the last saved settings will be showed.
Press button FUNC, it will return to the upper menu one by one.
