Moon manual.doc
5/14
Use the plug provided to connect the
mains power to the projector paying
attention to the voltage and frequency
marked on the panel of the projector. It
is recommended that each projector is
supplied separately so that they may be
individually switched on and off.
IMPORTANT
It is essential that each projector is
correctly earthed and that electrical
installation conforms to all relevant
standards. Power consumption of each
MOON is 280W at 220V.
The projector may be controlled by sound, auto
programmes or a controller, and it may be operated in
Stand-Alone automatic mode, in Master/Slave synchro
mode or in Controller mode. With the touch-switches
and the digital display. The DMX start address can be
easily set and the various setup options may be
configured.
TO SET THE DMX START ADDRESS
The display shows the DMX start address after the
projector is switched on (if you have already set the
DMX start address and saved it, the screen will display the last setting).
Press the UP or DOWN buttons to select the required DMX start address in the display.
Confirm your choice by pressing the ENTER button, this will save and set the DMX start address.
The display will show the latest setting each time when the projector is powered up.
In Stand-Alone mode, the DMX start address can be set at random.
In the Controller mode and Master/Slave mode, the DMX start address must be set correctly. (Refer
to “Controller mode” and “Master/Slave mode” sections).
SETUP OPTIONS - PROJECTOR CONFIGURATION
To browse through the various Setup Options, press the FUNC button consecutively. There are 11
option codes (1~9 and A, b), each code has a specific function. The functions provided are listed in
the following table.
Once you have selected the desired operation code, press the key UP or DOWN to select “n”
(means OFF) or “y “ (means ON). N = ON, Y = YES.
Press the key ENTER to save the selected function and configuration. If the display is showing “y”,
then the setting has been enabled. In the same way, if it was showing “n” when you pressed ENTER
the option has been disabled.
The green LED will flash during this operation.
OPERATION
POWER SUPPLY - MAINS
