Section V Control panel and operation
17
PE setting
value
0(10)
1(11)
2(12)
3(13)
4(14)
Programming
output time
Initiate action
command
Starting at the
beginning
Bypass
operation
Stop action
command
Stopping is
complete
(1)This way of working contains a 999 seconds timer which setted by the setting item P4.
If P4 is not 0, the start timing is according to the initial setting time setted by PE , when
the time is up changing the output state, if P4 is 0, changing the output state immediately.
The output of the reset time is to sustain 1 seconds after finishing the time delay setted by
P4 and in the state of readiness.
(2)The control cycle of programmable output timing is according to one starting
process, if re-start the motor , the last programming output process is automatically
stopped and re-started the programming process.
5-3-2.
PE is from 5 to 9 (15 ~ 19), the programmable output work is state output
mode, the setting of the working state output as tabled below
：
PE set value
5(15)
6(16)
7(17)
8(18)
9(19)
state of output
indication
Motor fault
conditions
Running
Readiness
Start state
Bypass state
(1)Programmable state output to indicate the working state of the soft starter, the time
setted by P4 is invalid in this mode. The factory setting of PE is 7, which indicates the
preparation state of soft starter, can start the motor in this state; programmable output is
in the failure state, which indicates the fault of the motor(Err05, Err06, Err07, Err08,
Err12, Err15 ), which is different from the function of
⑤
,
⑥
fault output terminals;
running state refers to non preparation or fault condition, which includes 3 process of
start, bypass, soft-stop.
(2)When PE> 9, the reset state of the programmable output (
③
,
④
No. external pin)
changed from normally open to closed, that is inverted output. Flexible using the
function of programmable relay output, which can effectively simplify the external
control logic circuit
。
5-4
Operation protection function of power on terminal
The jumper mode is selected, divided into two states.
Status 1: power terminal operation effective protection: external control starting
terminal before the power is in a closed state, soft does not respond to run the command
must first run the command to remove a and run the command again after the effective
soft response.
Soft fault reset time command to run effectively, soft nor the response command to
run, we must first run the command removed to eliminate the operation state of
protection.
Status 2: on the terminal operation protection is not valid: on the power, if the
external control starting terminal is in a closed state, then the automatic starting motor,
which is allowed to start on.
The J14 2, 3 short connected to state 1, J14 1, 2 short connected to state 2.
5-5
Other settings Description
