16
Pow’R’kraft Snow Blower PK30230L
16
Revision 9-28-16
Remove the existing rubber paddles by
loosening the screws and nuts which secure
them to the auger.
Secure the replacement rubber paddles
to the auger using the hardware removed
earlier.
Route the end of the new belt around the
auger pulley and slide the pulley back on
to the auger shaft. It may be necessary to
push down on the idler pulley to get the
auger pulley under the belt keeper.
Replace the screw and washer and tighten
securely.
Reinstall the belt cover removed earlier.
1
4.
5.
6.
2.
The snow thrower auger’s rubber paddles are
subject to wear and should be replaced if any
signs of excessive wear are present.
Auger Paddles Replacement
Do not allow the auger’s rubber
paddles to wear to the point where
portions of the metal auger itself
c a n c o m e i n c o n t a c t w i t h t h e
pavem ent. Doi ng so can resu lt
in serious damage to the snow
thrower.
T h e a u g e r p a d d l e s s h o u l d b e
replaced one at a time so that the
auger still attached can be used as
an example for positioning and re-
installing the new auger.
