19
ASSEMBLY
In order to familiarise yourself with the parts of the device, we advise you to study the overview picture and the
parts list carefully before you start assembly. Place all the parts on the floor and remove all packaging materials.
Use the present tooling for assembling the device. Before assembling please check whether all needed parts are
available (at the above of this instruction sheet you will find an explosion drawing with all single parts (marked
with numbers) which this item consists of.
Step 1: assembling the front and rear stabiliser
Attach the Front Stabilizer(73) and the Rear Stabilizer(1) to
the Main Frame(2) with Carriage Bolt (11), Domed Nut(15)
and Arc Washer(14).
Step 2: assembling the handlebar post and connecting the hand pulse cable
Connect the Sensor A1 and A2 and Tension Control wire B1
and B2 as shown in FIG.2, fix the Upright Post (7) with the
Main Frame (2) with Bolt (26), Arc Washer (27).
Install the U Shape handlebar(10) on the Upright Post (7)
with Arc Washer (27), and Domed Nut(36).
Note:
Tighten the Screw(26) and the arc washer(27) after
the STEP 3
Summary of Contents for FET6702
Page 4: ...4 HET PRODUCT...
Page 16: ...16 THE PRODUCT...
Page 29: ...29 DAS PRODUKT...
Page 41: ...41 18 LE PRODUIT...