Powermatic 1792205HK, Operating Instructions And Parts Manual

Page: 9 / 24

9
5.3 Tools required for assembly
12mm wrench (provided)
4mm, 5mm hex keys (provided)
Cross-point (Phillips) screwdriver
Note: A ratcheting socket wrench, and hand drill
with cross-point bit, will speed assembly time.
Approximate assembly time: 2 to 3 hours
5.4 Assembly
Do not connect dust collector
to power until it is assembled. Failure to comply
may cause serious injury.
1. Turn base upside-down (on cardboard or cloth
to prevent scratching) and install fixed (R) and
swivel (S) casters. Note: Swivel casters mount
below the platform. Tighten all screws securely,
and turn base upright.
In steps 2 through 4, tighten screws only enough to
secure the structure; do not fully tighten.
2. Position left stand panel (I) and insert screws
(HP2). Semi-tighten screws.
3. Install support frame (G) to left panel, and
position right panel (H). Semi-tighten all screws.
4. Install angle supports (E1) with button head
screws and washers (HP2/3). Semi-tighten.
Half of angle support should protrude upward.
5. Assemble handles (Y) and fully tighten.
Figure 5-3
Use hoist or forklift with hooks
through the eyebolts near the motor, to raise
housing assembly. Lifting equipment must be
properly rated for the load.
If neither is available, use at least 4 persons to
lift housing and set it upon the stand. Failure to
comply may cause serious injury and property
damage.
6. Lower main housing (A, Figure 5-4) onto angle
supports and down onto stand panels. Secure
with button head screws and washers (HP2/3).
Tighten all securely.
7. Fully tighten all screws on stand assembly.
Figure 5-4
8. Place 2-inch hose (K) on main housing and
tighten with hose clamp (B1). See Figure 5-5.
Figure 5-5