13
7.3.1
Remote controller reset
If the remote controller begins to function
improperly, it should be cleared and reset.
To clear the remote controller, press and hold reset
button (D, Figure 7-3) for 3 seconds until receiver
“beeps” 3 times.
To reset the controller:
1. Press reset button for 1 second until receiver
“beeps” once.
2. Press and hold “ON” button on the remote
controller until receiver “beeps” twice. (If you
are using multiple remotes, perform step 2 on
each remote before proceeding.)
3. Press and hold reset button (D) for 3 seconds
until receiver “beeps” 3 times.
The remote controller is now ready.
Figure 7-3
7.4
Dust hose connection
Use proper type hose to connect dust collector to
machine(s) being operated.
Dryer vent hose is not
acceptable for this purpose.
Secure hose at both
ends with proper clamps.
If an inlet port is not being used, it should remain
capped.
An open port will diminish the machine’s
efficiency, and may create a safety hazard.
Contact your nearest Powermatic distributor for a
line of Dust Collector hoses and accessories. You
can customize your installation and obtain
maximum performance with dust hoods, hoses,
clamps, fittings, and blast gates.
7.5
Filter auto clean
Canister filter cleaning is automatic. When the dust
collector is shut off, the cleaning baffles will rotate
one direction for 5 seconds, then the opposite
direction for 5 seconds.
The auto clean feature can be turned on or off, using
the toggle switch on the side of the control box (E,
Figure 7-3).
7.6
Negative pressure gauge
A differential, or “negative”, pressure gauge is
located near the start switch. See Figure 7-4. The
gauge measures internal pressure, or vacuum,
relative to atmospheric pressure, which is
considered to be “zero”. Thus, the gauge reading
should be preceded by a minus sign.
Gauge reading will vary based upon airflow and
quantity of dust being moved. The gauge will
generally show about 2.25~2.5 kPa during normal
operation with no wood dust blockage.
A gauge reading of about 2~2.1 kPa may indicate
dust build-up, requiring filter cleaning. Keep filter
cleaning on auto mode so that it activates each time
the machine is shut off.
A gauge reading under 1.8 kPa may indicate full
blockage of the filter. If filter is cleaned several times
but gauge continues to read in low range, the filter
may need replacing.
Figure 7-4
Summary of Contents for 1792205HK
