10
9. Turn cone upside down. See Figure 5-6.
10. Paste 1Wx38L inch foam tape (FT138) around
bottom lip of cone. Trim excess.
11. Work the hose (J) onto the cone, and secure
with clamp (P).
Figure 5-6
12.
Before installing the canister
, remove the
junction box cover. Make sure the green
grounding wire is secured to the screw, and the
cable going up to the switch is secured against
the panel by the cable clip. See Figure 5-7
13. Leave cover off for later wiring to power source
(see
sect. 6.0
).
Figure 5-7
14. Install canister filter (D1) to housing, with 8
button head screws and washers (HP2/3).
Tighten screws.
15. Assemble cone (P) to housing with clamp (M).
See Figure 5-8. Position cone so that flanges
face forward and are parallel to stand. Tighten
screw on clamp.
Figure 5-8
16. The upper drum is nested within the lower
drum. Remove clamp, and lift out upper drum.
17. Assemble upper drum (C, Figure 5-9) to lower
drum (D) and secure with drum clamp (V) by
tightening screw (V
1
).
18. Install handle (O) with screws (HP4). Handle
should be opposite side from lower ports.
19. Turn drum over and install casters (T) into
threaded holes beneath drum. Use the provided
wrench to tighten.
Figure 5-9
20. Paste 1Wx25L inch foam tape (FT125) around
the inlet port at its edge. Trim excess. See
Figure 5-10.
21. Push inlet adaptor (F) onto housing inlet and
tighten with screw.
22. Paste 1Wx38L inch foam tape (FT138) around
flange of drum lid (E).
Summary of Contents for 1792205HK
