PowerMate
®
Operation Manual
MOTOR REPLACEMENT INSTRUCTION For L-SERIES POWERMATE SN 42000 and higher.
INSTRUCTION: In order to remove and replace the motor, it is necessary to follow the "Procedure for Repairing the Drive Screw Assembly", as addressed in
the L-Series Manual. After the Screw Assembly is dis-engaged from the Motor, proceed with the following steps. Upon completion, return to
procedure in the manual for re-assembly.
Inside Battery Box Detail
Motor Side of Battery Box Detail
CAUTION:
Insure the Circuit Breaker
Toggle Switch is in the down position
during this entire procedure.
NOTE: The Axle has been removed for clarity.
Un-affected wiring removed for clarity.
NOTE: Refer to the Wiring Diagram in the
PowerMate L-Series Manual for
your unit to confirm proper hook-up.
NOTE: Ensure the Washer Plate
is under the Motor mounting
lugs when inserting bolts.
1. Disconnect the Black and Red Wires.
2. Remove the two nuts
securing the Motor.
3. Remove the Motor.
Install the new Motor onto
the two mounting bolts.
4. Align the Motor parallel to the Inner
Frame Extrusion and secure with
the two 1/4"Bolts and Nuts.
5. Re-connect the Black and Red Wires
to the new Motor terminals as show.
6. Refer to the L-Series Manual for this PowerMate unit
for the instruction for re-assembly of the Drive Screw
Assembly and the Outer Frame Assembly.
MOTOR PN050860D
Inner Frame Extrusion
Electronic Controller
Battery Box
Motor Mounting Bolts
DETAIL A
DETAIL B
A
B
PN011660C
01/ 28/ 19
5.11
