Powerline PHG-1000X, Owner'S Manual

Page: 30 / 34

PHG-1000X
STEP 7
BE CAREFUL TO ASSEMBLE ALL COMPONENTS
IN THE SEQUENCE THAT THEY ARE PRESENTED.
NOTE:
finger tighten all hardware in this step. DO NOT wrench tighten
until the last step. some components may be pre-assembled.
nylon lock nuts will not fully screw onto bolts, must wrench tighten.
*the directions below are for routing the cables for the
row bar, lat bar, and the right and left fly frames.
LAT BAR: use (#38) 3440mm steel cable. P1 -attach ball end to
snap link on lat bar. P2 -route bolt side of cable up and over
pulley attached to front opening of top frame (D). P3 -route
cable over and down pulley attached to rear opening of top
frame (D). P4 -route cable down and around pulley attached to
top of top pulley holder (P). P5 -route cable up and over
pulley attached to rear of top frame (D). P6 -remove cable bolt
(#45) from selector rod bolt (#44), slide metal ball end of
cable through selector rod bolt (#44). Attach cable end
shaft (#47) and securely tighten allen screw (#46). Pull
cable tight, so cable end shaft (#47) fits securely inside
selector rod bolt (#44). Reinstall cable bolt (#45) into
selector rod bolt (#44).
FLY FRAMES: use (#39) 3050mm steel cable. Q1 -attach
stamped eye end to hook on back side of right fly frame (K).
Q2 -route cable around right pulley attached to fly frame (I).
Q3 -route cable over and down right pulley attached to
angled frame (C). Q4 -route cable down and around top pulley
attached to bottom pulley holder (Q). Q5 -route cable up and
over left pulley attached to angled frame (C). Q6 -route cable
around left pulley attached to fly frame (I). Q7 -attach
other stamped eye end of cable to hook on back side of left
fly frame (J).
ROW BAR: use (#40) 3790mm steel cable. R1 -attach the ball
end to snap link on row bar. R2 -route the chain side end
under and through the pulley attached to pulley frame
(H). R3 -route the cable under the pulley attached to angled
frame (C). R4 -route the cable up and over the bottom pulley
attached to bottom pulley holder (Q). R5 -route the cable
down and around the pulley attached to mainframe (A).
R6 -route the cable back up and around the bottom pulley
attached to top pulley holder (P). R7 -route the cable down to
mainframe (A) and attach to eye holder using snap link (#30).
30