Powerline PHG-1000X, Owner'S Manual

Page: 28 / 34

PHG-1000X
STEP 6
BE CAREFUL TO ASSEMBLE ALL COMPONENTS
IN THE SEQUENCE THAT THEY ARE PRESENTED.
NOTE:
finger tighten all hardware in this step. DO NOT wrench tighten
until the last step. some components may be pre-assembled.
nylon lock nuts will not fully screw onto bolts, must wrench tighten.
important: this step is to show you where each pulley should
be assembled and what hardware to use. however, some of
these pulleys must be installed while routing the cables. be
sure not to tighten the hardware on pulleys until cable
routing is complete, which can be found in step 7.
6A. using the same hardware attach a pulley in the front
and rear openings of top frame (D), bottom of pulley
frame (H), and bottom of angled frame (C) using:
4 - (#4) M10X70mm hex head bolt
8 - (#32) 16mm steel bushing
4 - (#27) 74mm pulley
4 - (#13) M10 nylon lock nut
6B. using the same hardware attach a pulley to the pulley
holders on top frame (D) and mainframe (A), as well as to
top pulley holder (P) and bottom pulley holder (Q) using:
6 - (#5) M10X40mm hex head bolt
6 - (#27) 74mm pulley
6 - (#13) M10 nylon lock nut
6C. attach two pulleys to fly frame (I) using:
2 - (#3) M10X90mm hex head bolt
4 - (#15) M10 washer
2 - (#27) 74mm pulley
2 - (#13) M10 nylon lock nut
6D. attach two pulleys, one on each side to angled frame (C)
and stopper rod (W) using:
1 - (#2) M10X110mm hex head bolt
2 - (#15) M10 washer
2 - (#27) 74mm pulley
1 - (#13) M10 nylon lock nut
6E. attach a snap link (#31) and insert 1” round end cap
(#44) onto ends of lat bar (T) and row bar (U).
28