Powerline P1.1x, Owner'S Manual

Page: 26 / 69

Be careful to assemble all components in the
sequence they are presented.
Note:
All Pulleys in this step are 4 1/4” diameter, except where noted in step 9C.
Leave all pulley bolts hand tight until step 10 is completed.
A. See Diagram 1. Route Cable (91) up and through Upper Floating Pulley Bracket (V).
Route Cable (91) around Pulley (B5) and install Pulley (B5) using:
One 53 (10mm x 45mm hex head bolt) - No. 3 on hardware card 2
Two 60 (10mm washer) - No. 22 on hardware card 1
One 70 (10mm nylon lock nut) - No. 18 on hardware card 3
B. See Diagram 1. Route Cable (91) through Leg Press Pulley Bracket (W).
Route Cable (91) around Pulley (B6) and install Pulley (B6) using:
One 53 (10mm x 45mm hex head bolt) - No. 3 on hardware card 2
Two 60 (10mm washer) - No. 22 on hardware card 1
One 70 (10mm nylon lock nut) - No. 18 on hardware card 3
C. See Diagram 1. Insert Cable (91) through Upper Main Frame (D) and install 3 1/2” diameter Pulley (B7)
under Cable (91) as shown using:
One 52 (10mm x 95mm hex head bolt) - No. 6 on hardware card 1
Two 14 ( pulley spacer)
One 70 (10mm nylon lock nut) - No. 18 on hardware card 3
D. See Diagram 1A. Attach Short Cable (92) to Lower Main Base Frame (A) using:
One 52 (10mm x 95mm hex head bolt) - No. 6 on hardware card 1
One 60 (10mm washer) - No. 22 on hardware card 1
One 70 (10mm nylon lock nut) - on hardware card 3
E. See Diagram 1A. Attach the other end of Cable (92) to the hook on the bottom of Leg Press Pulley
Bracket (W).
G. You can now wrench tighten all bolts and nuts. Do NOT re-tighten any of the pad bolts.
S T E P
10
Ball Stop End
Small Ball End
Stamped Eye End
Stamped Eye End
Low Pulley Cable (91)
Short Cable (92)
26