Powerline P1.1x, Owner'S Manual

Page: 22 / 69

Note:
All Pulleys in this step are 4 1/4” diameter, except where noted in step 8c.
Leave all pulley bolts hand tight until step 10 is completed.
A. See Diagram 1. Route Cable (90) through the top of the Upper Floating Pulley Bracket (V).
Install Pulley (A7) as shown in Diagram 2 using:
One 53 (10mm x 45mm hex head bolt) - No. 3 on hardware card 2
Two 60 (10mm washer) - No. 22 on hardware card 1
One 70 (10mm nylon lock nut) - No. 18 on hardware card 3
B. See Diagram 1. Route Cable (90) up through the opening in Upper Main Frame (D).
Install Pulley (A8) under Cable (90) as shown using in Diagram 2:
One 52 (10mm x 95mm hex head bolt) - No. 6 on hardware card 1
Two 14 (pulley spacer)
One 70 (10mm nylon lock nut) - No. 18 on hardware card 3
C. See Diagram 1. Route Cable (90) through the pulley bracket in Upper Main Frame (D).
Install 3 1/2” diameter Pulley (A9) as shown using in Diagram 2:
One 53 (10mm x 45mm hex head bolt) - No. 3 on hardware card 2
Two 60 (10mm washer) - No. 22 on hardware card 1
One 70 (10mm nylon lock nut) - No. 18 on hardware card 3
D. See Diagram 1. Route Cable (90) through the pulley bracket in Rear Upper Beam (E) and then
down through the opening in Rear Upper Beam (E), and down toward weight stack.
Install Pulley (A10) under Cable (90) as shown using in Diagram 2:
One 53 (10mm x 45mm hex head bolt) - No. 3 on hardware card 2
Two 60 (10mm washer) - No. 22 on hardware card 1
One 70 (10mm nylon lock nut) - No. 18 on hardware card 3
E. See Diagram 1A. The Metal Ball End of Cable (90) should be hanging just above the weight
stack. Remove Bolt (59) from Selector Rod Top Bolt (34), slide Metal Ball End of Cable (90)
through Selector Rod Top Bolt (34). Attach Cable End Shaft (33) and securely tighten
Allen Screw (8). Pull Cable (90) tight, so Cable End Shaft (33) fits securely inside Selector Rod
Top Bolt (34). Reinstall Bolt (59) in Selector Rod Top Bolt (34).
NOTE:
Make sure the Selector Rod Top Bolt (34) is threaded inside Selector Rod (31) at least
one half inch. Make sure Spring Lock Washer (63) is in place and wrench tighten Jam
Nut (71).
Be careful to assemble all components in the sequence they are presented.
S T E P
8
High Pulley Cable (90)
Ball Stop End Metal Ball End
22