12
Connecting to Skid Steer & Transporting to Job Site
7. Hydraulic
components
Check the hydraulic components carefully:
1.
Visually inspect all hoses and clamps/fittings for cracks, fraying, kinks, or other
damage.
2.
Check all components for oily residue, which may indicate a leak.
Do NOT operate the log splitter if there is any indication of damage or oily residue. Small
leaks in hydraulic lines can cause severe injuries and can also be an indication of
catastrophic failure in the near future. The life of hydraulic hoses may be from a few
months to a few years, depending on use and storage patterns.
WARNING
:
High fluid pressures and temperatures are developed in hydraulic
log splitters. Hydraulic fluid escaping through a pin hole sized opening can burn or
puncture skin, resulting in wounds that could cause blood poisoning, infection,
disability, gangrene, amputation, or death. Therefore, the following instructions should
be heeded at all times when inspecting or servicing the hydraulic components of the
log splitter:
Stop the skid steer and move all split control levers back and forth to relieve
pressure before changing or adjusting hydraulic system components such as hoses,
tubing, fittings or other components.
NEVER check for leaks with your hand. Leaks can be located by holding a piece
of cardboard or wood (at least two feet long) with your hand at one end and
passing the other end over the suspected area (wear eye protection). Look for
discoloration of the cardboard or wood.
NEVER adjust the pressure of the pump or valve.
If injured by escaping fluid, no matter how small the wound is, see a doctor at
once. A typical injection injury may be a small puncture wound that does not look
serious. However, severe infection or reaction can result if proper medical
treatment is not administered immediately by a doctor who is familiar with
injection injuries.
8. Lubricate beam
Apply grease to beam.
This will help prevent wear between the wedge and beam.
Apply grease to beam
Apple Grease to Beam
