Proprietary & Confidential
Page 15 of 73
Connect the dashcam to an OBD2 port for power
To utilize the full features of the V-AI12 dashcam, including Standby mode, the dashcam must be
connected to a constant 12V or 24V minimum 2A power source using the supplied cables. You can
do this by connecting the dashcam to an OBD2 port. Purchase an OBD2 cable from your authorized
reseller.
Warning
This installation should be performed by a qualified or professional person only. Working with your
vehicle's power system can be dangerous. Consult a professional for guidance.
Note
While in
Standby
mode, you can retrieve recordings from the dashcam. In
Standby
mode,
the dashcam draws a current of 34 mA.
To connect your dashcam to an OBD2 port:
1.
Locate the engine diagnostic port.
The port is usually found in the driver area, at or below knee level.
2.
Align the connector end of the OBD2 cable with the engine diagnostic port.
Connectors can vary by vehicle. If a different one is needed, contact your authorized reseller.
3.
Push the connector into the port.
Note
Ensure that the OBD2 cable is secure and well-connected to the port.
Summary of Contents for V-AI12
Page 7: ...Proprietary Confidential support powerfleet com Page 7 of 73 Calibrate the dashcam sensors...
Page 14: ...Proprietary Confidential support powerfleet com Page 14 of 73 Calibrate the dashcam sensors...
Page 59: ...Proprietary Confidential support powerfleet com Page 59 of 73...
Page 61: ...Proprietary Confidential support powerfleet com Page 61 of 73...
