18
PowerBox-Systems
− World Leaders in RC Power Supply Systems
This is accomplished by moving the model in the directions shown in the graphic
display: first move the tail of the model up and down two or three times. You will
see that the elevators follow this movement every time - the direction of effect is
not important at this stage.
At the end of the movement hold the model’s tail
up
and wait until the elevators
return to neutral (centre).
Now repeat the procedure with the rudder (yaw) axis: move the tail to left and right
two or three times – then hold the tail to the
right
until the rudder returns to neutral.
The Assistant now continues to the process of establishing the directions of effect
(“sense”) and learning the transmitter control end-points. Before you carry out this
procedure, it is essential to set the direction of effect and the end-points of the pri-
mary functions at the transmitter.
Note:
This procedure can be awkward to carry out with larger models. However,
there is a simple trick which makes learning the installed position easier: don’t
fix the iGyroSAT in the model until
after
the learning process is complete. During
the learning procedure you simply move the
iGyroSAT
in the appropriate directi-
on, rather than the model itself!
Note:
At any time you can repeat the procedure in the Gyro menu for setting the
direction of effect and the end-points. This is absolutely essential in any case if
you adjust the travels or directions of effect of the primary functions while you
are setting up the model.
