Monitor Series PB# 4100031 Rev.B 09/11
PowerBoss, Inc. Copyright 2011
Page 71
13. Tighten the jam nuts on each mount plate.
Then tighten the bolt on top of each of the two
upper squeegee arms.
14. Tighten the nut on the caster.
15. Reattach the squeegee lift linkage.
16. With the squeegee in the down position and
the Impeller on, drive the machine forward
approximately two feet (.61 meters) and set
foot brake. Examine the flare in the squeegee
rubber to see that it is uniform around the entire
parabola. If not, go through Steps 4-15
17. Test unit for water pick up
NOTE: Raising the squeegee caster allows for more
flare, use the tilt adjustments to even the flare.
PREVENTATIVE MAINTENANCE