INSTALLATION EXPERIENCE
Installation of PowerBass mobile sound equipment requires detailed knowledge of electronics wiring and
proper speaker impedance. We strongly recommend installation by an authorized PowerBass Xtreme dealer.
This Owner’s Manual only provides general installation and operation instructions. If you have any reservations
about your installation skills, please contact your local PowerBass dealer for assistance.
PREPARING FOR INSTALLATION
NOTE: The tools listed below may be required for basic installation
•
An electric drill with bits
•
Philips head and standard screwdrivers
•
Wire strippers
•
Crimping tool
•
VOM (electronic volt ohm meter)
•
Heat shrink tubing and heat gun
•
Soldering iron
INSTALLATION SEQUENCE
1. Find a suitable location in the vehicle to mount the crossover. Do not mount the crossover
directly to the chassis, or any metal part, of the vehicle to ensure maximum noise rejection.
2. Bolt the crossover to the mounting surface, and make sure the mounting screws do not
touch any metal part of the vehicle to ensure maximum noise rejection.
3. Using the Power Plug provided connect 16 gauge, wire for Power, Ground and Remote turn
on signal, making sure to connect the Power and Ground to the proper location on the power
plug. Run 16 gauge, ground wire from the chassis of the head unit to the ground of the
crossover. The Power should be made directly to the (+)12 voltvehicle battery, or power
distribution point. The Remote should be connected via relay to the Remote Turn On lead
of your head unit (radio).
4. Connect all line inputs and outputs using high quality RCA interconnects.
5. Re-check all connections before powering the unit on.
6. Set all level controls to their minimum positions. Set all crossover points and switches to
the desired frequencies and positions.
7. Once the system is powered on, set the volume control on the head unit to 80% of maximum,
then set level controls on the crossover.
8. Further tuning of the controls may be necessary to obtain the desired results.