Poweramp LHP Series, Owner & User Manual

Page: 29 / 52

27
4111-0012 — Sept. 2018
© 2018 Systems, LLC
End Loading/Unloading
1. Check to make sure the transport vehicle is
positioned squarely against dock bumpers.
2. Instruct driver to remain at the dock until the
loading or unloading process has been completed.
3. Chock the transport vehicle wheels, or use a
vehicle restraint if available.
4. If transport vehicle bed is at or above dock floor
level, leave leveler at the cross-traffic position and
proceed with loading or unloading (see Figure 18).
If transport vehicle bed is below the dock floor level,
continue with Step 5.
5. Raise the platform by pressing and holding the
RAISE button until the lip extends just enough to
clear the lip keepers, then release the RAISE button.
6. Allow the platform to drift down to the full below-
dock position.
7. Proceed with loading or unloading (see Figure
19).
Operating Instructions (continued)
Figure 18
Figure 19
Note: When end unloading is finished and access
to the rest of the transport vehicles is still required,
the platform lip will need to be extended. See Ramp
Loading/Unloading Instructions on page 26 for further
instructions.
8. When end loading or unloading is finished, raise
the platform by pressing and holding the RAISE
button until the lip folds enough to land in the
lip keepers, then release the RAISE button. The
platform will return to the cross-traffic position.
9. Remove chocks from transport vehicle wheels, or
release the vehicle restraint if used.
10. Indicate to driver that the transport vehicle may
leave the dock.
OPERATION