![Power Tech Generators PT-10KSIC Operation & Maintenance Manual Download Page 8](http://html1.mh-extra.com/html/power-tech-generators/pt-10ksic/pt-10ksic_operation-and-maintenance-manual_1587886008.webp)
Page
8
of
41
Moving Parts
While in operation, there may be exposed moving parts.
DO NOT
wear loose, torn, or bulky clothing around the generator set.
Be sure all guards and shields are in place before operating the generator set.
Keep your hands and body away from all rotating parts, such as cooling fan, belts, pulleys, etc.
Stop and disable the generator set before servicing.
Fire
A fire can cause severe injury or death. To reduce the risk of fire:
DO NOT
smoke near the fuel system or fuel tank.
DO NOT
operate the generator set in the vicinity of spilled fuels or flammable vapors.
DO NOT
operate the generator set in the presence of fuel leaks, fuel accumulation, or other
flammable materials.
Keep the engine and engine bay clean and free of accumulated dirt, grease, and trash.
Keep the genset idling for 5-6 minutes before stopping. Temperatures around the genset may
increase suddenly.
DO NOT
fill the fuel tank near open flames or while smoking.
Shut down the generator set and allow it to cool before fueling.
DO NOT
run the generator set with a damaged, loose, or missing fuel cap.
If fuel or lubricants spill, clean up immediately and properly dispose of.
DO NOT
attempt to use ether or other starting aids. Doing so may cause a flash fire and/or
damage the engine.
Inspect and replace any damaged wiring if necessary.
DANGER
Moving Parts.
Will cause severe injury or death.
WARNING
Risk of Fire
Can cause severe injury or death.
Summary of Contents for PT-10KSIC
