14 | MICRO Installation & Owner’s Guide 2018 | www.power-pole.com
• Every 3 months inspect all electrical connections to ensure that they are secure and
add dielectric grease every 6 months to prevent corrosion.
• Prior to each use, inspect all hardware for proper tightness.
• The MICRO Driver Unit needs to be flushed out with water after each use.
(FIG. 5)
•
Power cord must be disconnected when the anchor is not in use or while charging
12 Volt DC battery.
NOTE:
Dust cover must be in place while power cord is disconnected.
• The MICRO Driver Unit has a quick release clamp for easy removal.
(See attaching and removing section in the Installation Manual.)
MAINTENANCE
and storage
+
Figure 5
With the spike removed, double tap the Key Fob or Dash Switch DOWN button to run the unit a full 30
seconds while simultaneously flushing with low flow water. Repeat as needed to clean all debris from spike
pocket mechanical parts.
