MICRO Installation & Owner’s Guide 2018 | www.power-pole.com | 11
Figure 2
OPERATING
the Power-Pole
MICRO
®
Anchor
Top Side Controls
(FIG. 1)
• The UP and DOWN buttons on top of the
MICRO Driver Unit can be used to retract and
deploy your Power-Pole MICRO anchor.
• While pressing the ANCHOR FORCE button, also press
the UP or DOWN to increase or decrease the anchor force
NOTE:
Anchoring force does not relate to stopping power.
• Check battery level by pressing the BATTERY LEVEL button.
Orange LED lights appear above indicator bars to show
levels of battery charge. Each bar represents 20% of charge.
Calibrating Your MICRO Driver Unit
For proper operation your MICRO Driver Unit must be calibrated to your spike. The Driver
Unit will read the length and surface smoothness of your spike and calibrate the distance and
pressure required for proper anchoring force.
IMPORTANT:
The Micro Driver Unit must have 21” inches between it and the ground for
accurate calibration
Calibration Instructions
(FIG. 2)
1. Insert the spike into the MICRO Driver Unit.
2. Press the ANCHOR FORCE and BATTERY LEVEL buttons on the top of the
unit at the same time. The driver unit will automatically start the calibration
process.
3. The unit will cycle the spike up and down for 30 to 60 seconds.
NOTE:
Do not touch the driver unit or spike during the calibration process.
4. Once the calibration is complete the programming LED will return
to flashing green. Your MICRO Driver Unit is now ready for use.
21” of
clearance is
required
to calibrate
Figure 1
LED Programming Light
UP
Program/Pair
DOWN
Anchor Force
Battery Level
