10/2A Battery Charger
4
For technical questions call: 1-800-665-8685
V 3.03
8155525
3. Double insulated tools are equipped with a polarized plug (one blade is wider than the other.)
This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician to install a polarized
outlet. Do not change the plug in any way. Double insulation eliminates the need for a three
wire grounded power cord and grounded power supply system.
4. Grounded tools must be plugged into an outlet that is properly installed and grounded in
accordance with all codes and ordinances. Never remove the grounding prong or modify
the plug in any way. Do not use any adapter plugs. Check with a qualified electrician if you
are in doubt as to whether the outlet is properly grounded. If the tool should electronically
malfunction or break down, grounding provides a low resistance path to carry electricity
away from the user.
5. Do not abuse the cord. Never use the cord to carry tools or pull the plug from an outlet.
Keep the cord away from heat, oil, sharp edges or moving parts. Do not operate this tool if
the power cord is frayed or damaged. Replace damaged cords immediately. Damaged cords
increase the risk of electric shock. Do not modify the plug in any way.
6. When operating a power tool outside, use an outdoor extension cord marked “W-A” or
“W”. These cords are rated for outdoor use and reduce the risk of electric shock. Use in
conjunction with a Ground Fault Circuit Interrupter (GFCI). If operating a power tool in a
damp location is unavoidable, the use of a GFCI reduces the risk of electric shock. It is
recommended that the GFCI should have a rated residual current of 30 mA or less.
7. Avoid using an unnecessarily long extension cord. Choose a cord that is appropriate for the
situation, as a cord that is too long and running across the floor can be more dangerous
than helpful. Using a cord that is too long or too thin could damage the tool. Unroll the cord
completely to prevent it from overheating.
8. Place the electrical cord in a position that prevents it from coming into contact with the tool
and from getting caught by the work piece. The cord should always stay behind the tool.
TOOL USE AND CARE
1. Use the correct tool for the job. Maximize tool performance and safety by using the tool for
its intended task.
2. Do not modify this tool or use for a purpose for which it was not designed.
3. This tool was designed for a specific function.
Do Not:
a. Modify or alter the tool; all parts and accessories are designed with built-it safety
features that may be compromised if altered.
b. Use the tool in a way for which it was not designed.
UNPACKING
1. Carefully remove the tool from the package.
2. Retain packing material until you have carefully inspected and satisfactorily installed or
operated the tool.
3. Inspect the parts carefully to make sure the tool was not damaged while shipping.
Summary of Contents for PTC-10C/1
Page 12: ......
