8823304
1 Ton Cable Puller with 2 Hooks
V4.0
6
For technical questions call 1-800-665-8685
OPERATION
Letter references in parenthesis (A) refer to the included Identification Key.
1. Hook the cable hook (I) onto the load or pulling device (straps, chains,
etc.) and check that the latch is shut.
2. Press down on the drive pawl button (E) to raise the drive pawls (D). Push
the drive pawl lever (E) down to keep the pawls raised.
3. Push the handle forward towards the cable hook (I). Push the stop pawls
(B) away from the ratchet drum’s teeth.
4. Pull out the amount of cable desired, leaving a minimum of three wraps on
the drum. Release the stop pawl and move the handle to the start position.
5. Clip the anchor hook (A) to the sturdy object capable of withstanding the
strain. Make sure the latch is fully shut.
6. Press down on the pawl button and push the drive pawl lever up.
7. Raise the handle to force the pawls into the ratchet teeth and advance the
spool to draw the cable onto the puller’s drum. Lower the arm to reset for
the next pull.
8. Repeat until the load reaches its final position. Check that the cable is
wrapping neatly on the drum. Do not allow it to pile up on one side or to
overlap in the middle.
9. Disengage the pawls (steps 2 and 3) and pull the cable puller to release the
cable tension. Disengage the cable hook and anchor hooks.
10. Recover the remaining cable onto the drum.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is efficient, easier to
control and will have fewer problems.
2. Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
3. Follow instructions for lubricating and changing accessories.
4. Only use accessories intended for use with this tool.
5. Keep the tool handles clean, dry and free from oil/grease at all times.
