V4.0
2 Bike Trunk Mount Bike Rack
8819427
Visit www.princessauto.com for more information
5
5. Repeat steps 1 to 4 on the other side of
the frame.
6. Slide a buckle assembly (#2) onto
an M8x65 hex head cap bolt (#6).
Repeat with other assembly and bolt.
Set both aside.
7. Position the top support (#5) with the
curve facing down. The support arm (#1)
has the clamps on top. Insert the support arm
onto the top support tube and align the bolt holes.
8. Slide the spacer (#4) to align with the bolt holes.
Make sure the arms fit snuggly in the groove as
there is a different groove on the other side.
9. Insert the bolt with the buckle assembly through
the arm bolt holes and spacer.
10. Align the protruding bolt and spacer groove with
the bolt hole above the strut. Fit the assembly together
so the bolt protrudes out the other side.
11. Thread a locknut (#7) onto the bolt, but do not tighten.
12. Repeat steps 7 to 11 on the other side.
13. Pull each strut (Fig. 3-1) forward and carefully bend
them inward to insert the hooked end into the top
support bolt holes.
CAUTION! Keep fingers a few inches away from rod
insertion point to avoid pinching.
14. Tighten the lock nuts on both sides.
15. There are six trunk straps, two upper straps (Fig. 4-1)
and four bottom/side straps (Fig. 4-2). The hooks of
each set are different.
16. Thread a trunk strap into a buckle from underneath,
over the strut and through the second opening (Fig. 5).
Fig. 2
Fig. 3
Fig. 4
Fig. 5
