V4.0
9 pc Slide Hammer Dent Puller Kit
8814436
Visit www.princessauto.com for more information
7
TAPPING SCREW OPERATION
1. Drill a hole into the dent that is smaller than the screw diameter.
a. You may need to pull a large dent out in sections. Pull out one part of
the dent before drilling the next hole.
2. Screw the tapping screw into the hole.
3. Screw the shaft into the nose cone until the tight.
4. Follow Operation steps 3 and 4 to remove the dent.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is efficient, easier to
control and will have fewer problems.
2. Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
a. replace the tapping screw with a new screw if damaged or blunted.
3. Follow instructions for lubricating and changing accessories.
4. Only use accessories intended for use with this tool.
5. Keep the tool handles clean, dry and free from oil/grease at all times.
6. Maintain the tool’s labels and name plates. These carry important information.
If unreadable or missing, contact Princess Auto Ltd. for replacements.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does not function
properly or parts are missing. If unable to do so, have a qualified technician
service the tool.
