8699159
4-1/2 in. Metal Cutting Band Saw
V4.1
14
For technical questions call 1-800-665-8685
ATTACH THE BAND SAW
1. Carefully set the Band Saw on top of the Stand assembly with assistance
and an adequate lifting device. Place the motor end of the Saw at the
wheeled end of the stand, making sure the upper section of the Stand fits
inside the base of the Band Saw.
2. Align the mounting holes on the base of the Band Saw with the mounting
holes (Fig. 3-1) located on the upper sections of the Stand assembly.
3. Secure the Band Saw to the Stand assembly, using a Bolt (#13) and Flat
Washer (#3) on the outside and another Flat Washer (#3), Spring Washer
(#4), and Nut (#5) on the inside of each of the six mounting holes (Fig. 4).
STOCK STOP ASSEMBLY
When mounted to the Band Saw, the adjustable Stock Stop assembly is used to
make repetitive cuts of the same length.
1. Slide the Shaft (#19) into the mounting
hole in the Machine Bed (#122), and
secure the Shaft by tightening the Set
Screw (#49 [Fig. 5]).
2. Slide the Stock Stop (#18) onto the
Shaft, and secure by tightening the
Screw (#17)
.
TO ATTACH THE PULLEY COVER
1. Open the lid of the Pulley Cover (#101) and position it over the Spindle Shaft
(#97) and Motor Shaft (Fig. 6-1).
Fig. 3
Fig. 4
Fig. 5
