8532251
7.5A Rotary Hammer
V4.0
8
For technical questions call 1-800-665-8685
UNPACKING
WARNING! Do not operate the tool if any part is missing. Replace the
missing part before operating. Failure to do so could result in a malfunction
and personal injury.
Remove the parts and accessories from the packaging and inspect for damage.
Make sure that all items in the contents are included.
Contents: • Rotary Hammer
• 6 in. SDS Masonry Drill Bits (3)
• 9-1/2 in. Chisels (Flat and Needle) (2) • Storage Case
IDENTIFICATION KEY
A Drill Bit
B Dust Cap
C Locking Sleeve
D Selector Switch, Front
E Trigger
F
Depth Gauge
G Auxiliary Handle
H Selector Switch, Rear
I
Handle
J
Power Cord
ASSEMBLY & INSTALLATION
Numbered references in parenthesis (#1) refer to the included Parts List. Letter
references in parenthesis (A) refer to the included Identification Key.
1. Reposition the auxiliary handle (G) by turning it counterclockwise to loosen
it. Rotate the handle to the new position. Turn the handle clockwise to
tighten and secure it.
2. Install the drill bit or chisel (Fig. 2).
a. Slide the dust protector onto the
drill bit’s butt if the bit angle can
result in debris falling into the drill.
Fig. 1
Fig. 2
