5 in. Angle Grinder
18
For technical questions call: 1-800-665-8685
8336174
V 2.5
REPLACING CARBON BRUSHES
NOTE:
Always replace all carbon brushes at the same time.
1. Using the included parts list, locate the carbon brushes.
2. Remove the screws from the body.
3. Pry the main body of the tool open using a flat head screwdriver.
4. Remove the old brushes.
5. Insert the new brushes.
6. Run the motor for at least 15 minutes without load to align the new brushes
with the commutator.
LUBRICATION
All bearings in this tool are lubricated with a sufficient amount of high grade lubricant for the life of the
tool under normal conditions. Therefore, no further lubrication is required.
DISPOSING OF TOOL
If your tool has become damaged beyond repair, do not throw it out. Bring it to the appropriate
recycling facility.
TROUBLE SHOOTING
If the tool does not function properly or if it is missing parts, contact Princess Auto Ltd. for a solution. If
unable to do so, have a qualified technician service the tool.
Problem(s)
Possible cause(s)
Suggested solution(s)
The tool will not operate
Power supply is incorrect for the
tool’s electrical rating.
Plug the tool into a 120V 60 Hz
power supply
Tool is not properly attached to
the power supply.
Ensure that the tool’s power cord
is connected securely to the power
supply and that the cord is not
damaged in any way.
The wheel moves slowly
The wheel may not be
securely attached
Tighten the nut that attaches the
wheel to the spindle.
The tool components may
need cleaning.
Disconnect the tool from the power
supply and clean the components of
the spindle.
Smoke results from
operation of the tool.
There is a buildup of rust or
debris in the wheel.
Immediately switch off the tool and
disconnect from power
supply. Remove the wheel from
the spindle and clean all
components thoroughly.
