5 in. Angle Grinder
17
Visit www.princessauto.com for more information
8336174
V 2.5
INSPECTION
1. The stator (motor) is the heart of the power tool. Exercise care to ensure it does not become
damaged by oil or water. Do not use the tool until you have discovered and corrected the
problem if you hear the stator making unusual noises or if you notice smoke or sparks coming
out of the stator.
2. Inspect the carbon brushes regularly and replace them when 2/3 of each brush is worn down.
3. Inspect all mountings and screws regularly and ensure that they are properly tightened.
4. Inspect the grinding wheel and ensure that it is free of cracks and surface defects. Replace the
grinding wheel immediately when it becomes worn down.
MAINTENANCE
CAUTION! Disconnect the power cord from the power supply before any maintenance or cleaning. Do
not use water or corrosive fluids to clean electrical parts of the tool.
1. Maintain the tool with care. A tool in good condition is efficient, easier to control and will
prevent unnecessary problems.
2. Keep the tool handles clean, dry and free from oil/grease at all times.
3. Follow instructions for lubricating and changing accessories.
4. Inspect the tool fittings periodically. Have damaged or worn components repaired or replaced
by an authorized technician.
5. Inspect the tool fittings, alignment, power supply cord and components periodically. Have
damaged or worn components repaired or replaced by an authorized technician.
6. Sharp tools are safer than dull tools. Applying excessive force while using a dull tool can lead to
slips and cause damage to your work piece or personal injury.
7. Maintain the tool’s label and name plate. These carry important information. If unreadable or
missing, contact Princess Auto Ltd. for replacements.
8. Periodically check the carbon brushes and replace worn out brushes (see Replacing
Carbon Brushes).
9. Keep the vent passages clear of accumulated dirt, dust, and oil.
10. Clean the tool after each use.
CAUTION! Only qualified service personnel should repair the tool.
