Power Fist 8142564, Owner'S Manual

Page: 7 / 14

Noise
• Prolonged exposure to noise levels above 68 dB is hazardous to hearing. Always wear ANSI approved ear
protection when operating or working around the generator when it is running.
Chemicals
• Avoid contact with hot fuel, oil, exhaust fumes, and hot solid surfaces.
• Avoid body contact with fuels, oils, and lubricants used in the generator. If swallowed, seek medical treatment
immediately. Do not induce vomiting if fuel is swallowed. For skin contact, immediately wash with soap and
water. For eye contact, immediately flush eyes with clean water and seek medical attention.
Extension Cord
If an extension cord (not included) is used, make sure to use only UL approved cords having the correct gauge and
length according to the following table:
Amperage 0 to 50 ft 50 to 100 ft
15 -20A 10 gauge 10 gauge
Battery
This product does not need a battery.
Assembly
No assembly is required.
Operation
NOTE: THE PARTS LISTED ABOVE ARE HELPFUL FOR LOCATING THE
CONTROLS MENTIONED BELOW.
CAUTION: PRIOR TO FIRST USING THE GENERATOR, THE ENGINE MUST BE
FILLED WITH OIL OF A HIGH QUALITY SAE 10W30 GRADE
ENGINE OIL. TO DO SO, UNSCREW AND REMOVE THE ENGINE'S
OIL DIPSTICK LOCATED AT THE BOTTOM OF THE ENGINE
CRANKCASE. FILL THE ENGINE'S CRANKCASE UNTIL THE OIL
LEVEL IS LEVEL WITH THE UPPER MARKED LINE ON THE
DIPSTICK. THEN SCREW THE DIPSTICK BACK INTO THE OIL
FILL HOLE.
Before Starting the Generator
1. Check that the engine power switch is in its “OFF” position.
2. Before the first use, remove the fuel tank cap and fill the fuel tank with unleaded gasoline. When fueling, be
sure that the fuel strainer is in place. Replace the fuel tank cap. Thereafter, check the engine's fuel gauge for the
amount of unleaded gasoline in the fuel tank. If necessary, refill the fuel tank with unleaded gasoline; the
generator must be turned off and cooled down before refilling the fuel tank.