Operation Instructions
Inserting Battery
Set rotation direction switch to centre position (lock out.) Insert charged battery
in handle and secure with battery retaining clip. The spring should snap into
place.
Switching on and off
• Set the rotation switch to the desired position
• To switch on: press and hold on/off switch
• To switch off: Release on/off switch
Switching direction of rotation
Set rotation switch either to R (clockwise) or to the opposite
side (counter-clockwise.) The counter-clockwise, or reverse,
direction is suitable for loosening screws and nuts. When the
ON/OFF switch is activated, rotation direction switch is
locked. Only change the direction of rotation when the
machine is not in operation.
Screws
Screwdriver Bits.
Clamp screwdriver bit directly into the chuck. Use additional universal bit
holder when using screwdriver bits.
Torque control setting
6 different settings can be selected with the torque control
ring.
1
is the lowest setting, ideal for small screws and soft
materials.
Drill
is the highest setting, ideal for large screws and
harder materials.
If the correct setting has been chosen, an override clutch opens once the screw
has been turned flush into the material. When removing screws, select a higher
setting or set to drill symbol. The proper settings are best determined in practical
trials.
Right
Left
Increase
Lower
8056608manual 3/11/05 2:54 PM Page 5
