Power Electronics ProfiPower SD700 Type 1, Manual

Page: 19 / 45

POWER ELECTRONICS SD700
–
PROFIBUS
INSTALLATION AND CONNECTION
17
E
N
G
L
I
S
H
TERMINALS DESCRIPTION
D101 (Led)
Red. It provides information depending on the number of
blinking.
Number of
blinks
Description
1 CAN communication error
2 Profibus Configuration error
3 VPC3 fault
4 Profibus not yet configured
5 Device in data exchange mode
3.2.2. Profibus Connections
For Profibus connection, a standard connector SUB-D 9 pins is used
according to the definition of the standard EN 50170. The wiring for
the connector of nine pins is shown in the attached figure.
If additionally, more information is
required, refer to “Installation
Guide of PROFIBUS DP/FMS" of the Profibus users group, where
you can find more detailed information about the connection.
Figure 3.3 Connections of the connector SUB-D 9 pins