Powercraft
11
•
Press the locking buttons (10) on both sides before removing the battery, and disengage
the battery from the base of the appliance.
4.
OPERATION
Always follow the safety notes and the relevant safety code.
Fig. D
Hold the appliance firmly and press the drill cutter steadily onto the workpiece. Do not overload
the appliance. Only use drill cutters with no visible wear. Worn drill cutters will have a bad effect
on the functioning of the appliance.
Adjusting the speed
The appliance has two drill speeds.
•
For slow drilling or for driving or removing screws, set the speed selection switch (2) to '1'.
•
For fast drilling set the speed selection switch to '2'.
Never switch over when the motor is running!
Adjusting the torque
Fig. E
The appliance has 16 different torque settings with which to set the power for driving and
removing screws.
•
Set the torque adjustment ring (3) to the desired position. The available torque settings are
indicated on the adjustment ring by the numbers 1 to 8 and by dots between the figures to
define intermediate settings (16 in total).
•
You should preferably choose as low a setting as possible when using the screwdriver.
Select a higher setting if the motor slips.
Driving and removing screws
•
Set the direction reversing switch (6) to position 'R' in order to drive screws.
•
Set the direction reversing switch to position 'L' in order to remove screws.
Drilling
•
Rotate the torque adjustment ring (3) to the drilling position.
Ensure that the direction reversing switch (6) is always set to 'R' during drilling.
GB
D
NL
F
E
P
I
S
SF
N
DK
Powercraft
15. Never throw the battery block onto a fire or into water. This will risk explosion!
Electrical safety
Always check that the voltage on the batterypack corresponds to the voltage on the
rating plate. Also check that your mains voltage corresponds to the input voltage of
the battery charger.
The battery charger is double insulated; therefore no earth wire is required.
Replacing cables or plugs
Immediately throw away old cables or plugs when they have been replaced by new ones. It is
dangerous to insert the plug of a loose cable in the wall outlet.
•
Remove the battery block. When the power tool is not being used, prior to maintenance and
when changing tools such as the clamping chuck, and drill.
•
The tool is suitable for use as a screwdriver and drill. Any other application is specifically
excluded.
3. MOUNTING ACCESSORIES
Prior to mounting an accessory always remove the battery.
Fitting and removing drill cutters
Fig. B
In addition to drill cutters, the tool can also accommodate screwdriver bits with a hexagonal
shaft.
•
Loosen the drill chuck (4) by rotating the hand-grip (9).
•
Insert the shaft of the drill cutter into the chuck.
•
Tighten the drill chuck so that the drill cutter is firmly clamped.
•
Rotate the drill chuck in the opposite direction when you wish to change the cutter.
Connecting and removing the battery
Fig. C
Ensure that the exterior of the battery block or tool is clean and dry before
connecting the charger.
•
Ensure that the direction reversing switch (6 Fig. A) is in the central position in order to
prevent the appliance from being switched on unexpectedly.
•
Insert the charger (5) into the base of the appliance, as shown on the illustration. Push the
battery until it latches in.
10
GB
D
NL
F
E
P
I
S
SF
N
DK
