![background image](http://html.mh-extra.com/html/power-craft/99033/99033_instruction-manual_1586396047.webp)
47
NO
SE
FI
GB
DE
DK
PL
ET
Adjusting the runners
The runners (14) act as buff ers between the
machine and the ground.
If using the machine on a slightly uneven or
loose surface, lower the runners.
Slacken the nuts on each side and push the
runners downwards. Adjust and secure one
runner at a time.
Preparation for use
Remove the oil fi ller cap. Check the oil level
using the dipstick on the underside of the
cap and top up if necessary. Replace the
cap.
Remove the petrol tank fi ller cap and check
the petrol level (3).
Top up with petrol if the level is too low.
Replace the cap.
Remove the butterfl y nut on the top of the
air fi lter (11), remove the air fi lter and check
the fi lter element is clean. Clean the fi lter
element if necessary (see Cleaning and
maintenance), and refi t the fi lter.
Starting the engine
Open the petrol cock (19).
Set the throttle lever (17) to the maximum
setting and press the primer (16) by the
carburettor 5-6 times to pump fuel into the
engine.
If starting from cold, push the choke (18) in
the direction of the arrow to increase the
fuel mix richness.
Manual start
Gently pull the starter handle until you feel
resistance, and then pull strongly to start
the engine.
NB! Do not allow the starter handle to recoil
freely as the handle may become damaged
upon impact with the machine.
Electric start
Place the ignition key (21) in the ignition
lock (20) and turn to the Start position.
Release the key as soon as the engine starts.
The circuit relay will turn off if the starter
engine risks overheating. If this occurs, press
the button (22) and wait a few minutes
before trying to start the engine electrically
again, or start the engine manually.
After start
Allow the engine to warm up and then push
the choke back, a few times if necessary.
Check that the engine is running smoothly.
The engine speed can be adjusted using the
throttle lever.