![background image](http://html.mh-extra.com/html/power-craft/99033/99033_instruction-manual_1586396046.webp)
46
GB
Connect the gear shaft lowest down on the
rear of the snow blower to the gear stick on
the control panel.
Push the handle (10) for turning the chute
through the holder on the handlebar and
insert the end of it into the universal joint.
Lock the handle securely in the universal
joint using a split pin.
Fit the discharge chute using 3 sets of the
following: 1 curved top and bottom plate, 2
bolts and 2 lock nuts. The nuts must not be
tightened too much, as the chute will then
be unable to turn round.
Secure the cable from the handle (7) in the
bracket on the fl ap (2).
Lubricate the lubricating nipple by the
blade drive using a grease gun.
Adjusting the discharge chute
You can set adjust the direction of discharge
by moving the handle (18) clockwise or
anticlockwise. You can also set how far the
snow will be discharged by altering the fl ap
angle (8) using the butterfl y screw (9). The
steeper the angle, the further the snow will
be discharged.