![background image](http://html.mh-extra.com/html/power-craft/54846/54846_instruction-manual_1586402017.webp)
17
ENGLISH
INSTRUCTION MANUAL
Use
The air cut off tool is suitable for cutting and
sawing rod iron, flat bars, angle iron, etc. and all
forms of piping and hollow metal profiles.
•
Connect the tool to the compressed air supply.
•
Secure the workpiece.
•
Keep your hands away from the blade, and
turn on the machine by pressing the switch
(4).
•
Guide the blade slowly down towards the
workpiece.
•
Do not put excess pressure on the blade, just
allow it to work its way through the item.
•
Once the item has been cut, the blade must be
lifted and the tool disconnected.
•
Remember that cut surfaces can get very hot.
Replacing the blade
•
Disconnect the tool from the compressed air
supply.
•
Remove the protective guard (1).
•
Undo the outer flange (2), and remove the
blade (3).
•
Clean the individual parts, and fit the new
blade by assembling the parts in reverse order.
•
Make sure that the blade does not jerk from
side to side when rotating. If so, remove the
blade and refit it carefully.
Cleaning and maintenance
If the compressed air supply does not mix
lubricating oil with the air, lubricate the tool with
oil via its compressed air nozzle after every 1-2
hours of operation. Apply a couple of drops of oil
to the nozzle, connect the tool to the hose and
run it for a few seconds to lubricate it. Lubricate
the tool with 4-5 drops of oil by the same method
after use. Do not use oil thicker than that supplied
(SAE-10), as this may damage the tool.
Clean the tool with a slightly damp cloth after use,
and always keep all surfaces clean.
Summary of Contents for 54846
Page 21: ...21 EXPLODED VIEW ...
Page 22: ...22 PART LIST ...