Power Computing Power 100, User Manual

Page: 43 / 92

Upgrading Your Computer
For Technical Support, Call 1-800-708-6227
Power 100/120 User Guide
25
Removing a SIMM.
1.
If you need to remove a SIMM module to make room for a higher-capacity
one, reach in and push down and out on the tiny handles which stick up
from the small metal SIMM clips at each end of the SIMM slot.
2.
The SIMM clips should click loose and module should tilt to the left so that
you can then slide the module out of the slot at about a 60 degree angle.
3.
If the SIMM module does not come free, press the SIMM clips down again
and try to push the top of the module gently away from the drives.
4.
When you are Þnished with SIMM removal and insertion, re-connect the
ßoppy disk drive connector, the CD audio connector (below the ßoppy
connector), and the speaker connector (below the CD audio connector)
from the I/O board and move those cords out of the way and replace the
cover.
DR
SIMM clip
front
SIMM clip
SIMM
Module