Power Computing Power 100, User Manual

Page: 37 / 92

Upgrading Your Computer
For Technical Support, Call 1-800-708-6227
Power 100/120 User Guide
19
To install an expansion card:
1.
Remove the computerÕs cover.
See ÒRemoving the cover,Ó starting on page 13 for instructions.
WARNING! Turn off the main power switch before removing the cover and make sure
to touch the metal plate over the hard disk to discharge static electricity
before touching any components.
2.
Remove the metal cover from the slot you want to use.
To remove the cover, pull it up and away from the back panel.
3.
Remove the card from its static-proof bag.
Hold the card by its edges to avoid touching components.
4.
Align the card over the slot.
Make sure that the connector on the bottom aligns with the connector inside the slot and
that the hole in the cardÕs bracket aligns with the tab on the inside of the back panel.
5.
Push the card into the slot until it is Þrmly seated. The hole in the cardÕs
bracket should snap into place over the tab on the back panel.
Do not force the card. If you feel a lot of resistance, pull the card out, realign it, and
insert it again.
NuBus card