Installation and Operating Instructions PBX-200 PB / Li
page 11
7
Installation
Only the installation of the power Blox is described below. When installing external
components (solar module, load, cable), observe the instructions of the respective
manufacturer.
Topics
1.
Safety Instructions
2.
Connections and Operation
3.
Setting up the Power-Blox
4.
Make electrical connections
7.1
Safety Instructions
DANGER!
Danger to life through electric shock! Observe the following safety instructions when
performing the steps described in the Installation section.
General
-
Only qualified personnel are allowed to perform the measures described in the
"Installation" section.
-
Power-Blox housing does not open.
The installation flap (14) must be closed and screwed during operation. Before working
with the Power-Blox, always carry out the following measures:
1.
Switch off all consumers.
2.
If present, open the DC load disconnector (solar module) and secure against
restarting.
3.
Open external fuses in front of the generator / mains and transfer terminals and
secure against restarting.
Cabling
-
The module cables carry voltage when the solar module is illuminated.
-
If the terminals of the mains/generator input (18) are used, the pre-installed cables
must be removed from the terminal block and individually isolated.
-
Isolate the open cable ends with an insulating tape or a luster clamp.
-
Connect the cables from the solar module and the consumers to the Power-Blox in
the order described.
-
Secure the connected cables with a strain relief (20).
-
Connect only 1 line to each connection terminal.
