Powered by Safety
®
12
Installation
EcoVisor™
01.4IB.48080
Ch 4 Installation
A. M
ountinG
The mounting of the EcoVisor™ is intended to be in any high voltage compartment including bus
compartment, rear cable compartment, or circuit breaker compartment. The EcoVisor can be
mounted with two plastic rivets (PN: PDM-ANT-RIVET) or on 0.25” PEM studs. Dimensions for the
mounting holes are shown in
(NOT TO SCALE). Refer to
Appendix A Mechanical Drawings
for a
1:1 drawing.
Figure 6
EcoVisor™ Mounting Pattern
THIS WAY UP
KEEP OUT FOR CABLES, OPTICAL SENSOR,
AND RH/T SENSOR REPLACEMENT
140.1 [5.516 in]
126.
7
[4
.987
in]
98.8 [3.889 in]
20.7 [.814 in]
20.7 [.814 in]
30.0 [1.181 in]
B. e
lectricAl
c
onnection
The EcoVisor has two 6 conductor modular jacks which are connected internally to provide easy daisy
chaining of several devices. Pre-terminated cables are available from Powell, refer to
Table C, Part Numbers for RJ12 Cables
. The RJ12 breakout adapter listed in
is used to provide
discrete wire terminations connected to the RJ12 wiring. The pinout of the jack is shown on the front
label of the EcoVisor as shown in
.
