Powell BriteSpot Plus, Instruction Bulletin

Page: 42 / 74

Powered by Safety
®
32 Usage
01.4IB.48041
BriteSpot
®
Plus
vi. The MCS status page ( Figure 38 )
allows the user to view the
communication status, slave ID,
polling rate, and measured current
of each connected MCS device.
Figure 38 MCS Status Page
vii. The EcoVisor™ status page
( Figure 39 ) allows the user to view
the communication status, slave ID,
polling rate, and measured values of
each connected EcoVisor device.
Figure 39 EcoVisor
™
Status Page
B. c
onfiGurAtion
1) Web Interface
a. Connecting to the Device
i. Connect a CAT5 Ethernet cable
directly between the Ethernet ports
on the computer and BriteSpot® Plus
to be configured.
ii. Ensure the power is connected to
the device and link is established.
iii. Type in the IP address in the browser
(default: 192.168.1.51; for details on
how to view the current IP see
Table F Menu Navigation )
iv. From the homepage the user can
navigate through the rest of the site
by clicking on the menu options of
the navigation bar on the left.
Note: If connecting via Ethernet directly
to a computer, the Internet Protocol
Version 4 IP address must be set in the
network settings on the computer. For
guidance see Appendix E .
b. Configuration Pages
i. Credential Validation
The changing of any parameters will
require a username and password.
The default values are:
Username: admin
Password: admin
To log in, navigate to the login page
( Figure 40 ) by clicking “login” at the
top right of the page.