- 8 -
0700_GB-EINsTELLUNGEN_9762
adjustments
DK
Setting for operation
1. The implement must be attached to the tractor in a horizontal
position, it should not hang to one side.
2. The front and rear tine rows must penetrate the ground at the
same depth (working depth).
The frame should sit parallel to the ground surface as seen
longitudinally.
3. Fix the lower link (4) in such a way that the machine cannot swing
out sideways.
Equipment variants and wearing parts
rigid tines (basic equipment)
Spring-mounted tines (optional extra)
• Can be backfitted on all types
Backfitting kit (2 & 2a)
(see spare parts list)
- Basic setting =
330 mm
wearing parts
- are screwed to the tines and can therefore be replaced at little
cost.
Overloading
Shearing screws
Tines are secured with shearing
screws.
The shearing screw (pos. 7) breaks
when overloaded and the tine
swings upward.
- Remove the shearing screw
remains.
- Loosen hexagonal screw (6).
- Swing tine back to working
position.
- Insert new shearing screw and
tighten both screws.
important!
Only use genuine shearing screws (see spare parts
list) of appropriate dimension and quality. under no
circumstances use screws with a greater or lesser
strength.
344-05-14
7
6
Hollow discs
- serve to level out the ground surface evenly.
Setting the hollow discs
• This setting should suit the relevant operating conditions (type
of ground, speed and straw layer on the ground).
• The hollow discs are always set at the required working
depth.
Only fine adjustment is necessary
344-05-14
7
6
