0700_GB-kOmBI-RAD_983
GB
FEELER WHEEL
- 2 -
working position
115-07-15
1
COMBI-wheel (Feeler and transport wheel)
As feeler wheel
• The working depth is set using the spindle (1)
If the adjustment range of the spindle is insufficient, the working
depth can be additionally set using both adjusting screws (2). In both
turning positions the varying working depths can also be levelled
out with the screws (2).
As transport wheel
• The COMBI-wheel
can also be used as a
transport wheel. Doing
this relieves the tractor’s
rear axle and lifting
gear.
Tyres
10.0/80-12 12 ply
Max. 5 bar pressure.
transport position
Changing to working position
- Lift the plough with the tractor’s lifting gear.
- Release locks (for safety reasons do this from the tractor seat with
the rope (S)
With that swivel the control lever 90° (position A).
- The turning unit positions the plough vertically.
- Remove bolts (3), swivel the support wheel console about 90°
into working position and pin with the bolts (3) again (see diagram
"Working position“). Secure bolts with linch pin (5).
Changing to transport position
- Remove bolts (3), swivel the support wheel console about 90° into
the transport position and pin with the bolts (3) again (see diagram
"Transport position“). Secure bolts with linch pin (5).
- Release locks.
With that swivel the control lever (on the attaching frame) 90°
(position T).
- Lift the plough with the tractor’s lifting gear.
- The turning unit slowly positions the plough horizontally until locking
bolts on the attaching frame automatically engage.
Important advice:
When transporting,
the upper link must
only be pinned in the
slot with the plough
