Cleaning of machine parts
Attention
! Do not use high-pressure washers for the cleaning of
bearing- and hydraulic parts.
- Danger of rust!
- After cleaning, grease the machine according to the lubrication
chart and carry out a short test run.
- Cleani ng with too high pressure may do damage to varnish.
Winter storage
- Thoroughly clean machine before storage.
- Put up protection against weather.
- Protect exposed parts from rust.
- Lubricate all greasing points according to lubrication chart.
8
h
FETT
TD47/94/17
TD47/94/17
Drive shafts
- Lubricate the drive shafts every 8
hours of operation.
- Pull sliding sections apart and
grease well.
Transmission
- see chapter "Special fittings"
Maintenance and servicing
In order to keep the machine in good condition even after a
longer period of operation, please observe the following notes:
Safety points
• Turn engine off when
adjustment, service and
repair work is to be done.
• Do not work under the
machine without safe support.
- After the first hours of operation, tighten all
screws.
In particular the tine connections and the slewing
headstock connections should be checked.
- Always keep the stipulated air pressure in the
tyres.
• Grease the lubrication points in accordance with the
regulation (see lubrication schedule).
Grease the lubrication nipples with universal grease after
every 20 hours of operation.
- Both sliding sections used for setting the operating width
should also be protected from corrosion.
- Before leaving the machine over winter, oil all the joints well
and grease all bearings.
Lubrication chart
GB
MAINTENANCE
296 / WARTUNG / 9900-GB
- 12 -