- 29 -
1901-EN Wartung_2858
maInTenance
EN
- Do not stand too close the tyre when inflating it!
- Only use compressed air to inflate the tyres.
- Observe the maximum allowed air pressure.
Allowed air pressure - see Chapter "Technical Data".
Tyres
Dimensions
Pressure
Chassis
340 / 55 - 16 AND -50 *
260 / 70 - 15 AND 0
15.0 / 55 -17 12 PR AS -54/6L
1.5 bar
1.5 bar
1.5 bar
Rotor
16 / 6.50 - 8 10PR
1.5 bar
Tyres marked * may only be mounted in the position that is narrower due to the offset, otherwise
excessive forces will act on the steering. (See illustration)
289-12-34
ET -50 / -54
Setting the tracking of the tyres
The track of the left and right tyres can be adjusted sepa-
rately behind the steering rods.
2
3
1
4
1. Loosen the locknut (1)
2. Remove dowel pin (2)
3. Keep the washer (3) in a safe place
4. Pull the steering rod away upwards.
5. Turn the spindle (4) until the required steering axle
position is reached.
6. Refit steering rod and secure with dowel pin (2).
- Set the toe-in to maximum 5mm. This means the distance
of the tyre's front edge must be 5 mm less than the
distance of the tyre's rear edge. (in direction of travel)
Adjusting the chassis running
The chassis is steerable. The swivel mounting bracket
transmits the steering movement to the chassis via a
steering rod. If the basic setting is optimal, the chassis will
run in line with the tractor when driving straight ahead. (M)
Running can be adjusted over the length of the steering rod.
A Spindle (3) must be screwed in.
B Spindle (3) must be screwed out.
M
044-01-009
A
B
The adjustment unit is located on the headstock.
1
2
4
3
1. Loosen the locknut (2)
2. Remove dowel pin (1)
3. Keep the washer (4) in a safe place
4. Pull the steering rod away upwards.
5. Turn the spindle (3) until the required steering axle
position is reached.
6. Refit steering rod and secure with dowel pin (1).